Center Of Gravity (Cg); As3X Control Direction Test (Bnf Basic); In Flight Trimming (Bnf Basic) - Horizon Hobby E-flite Turbo Timber 1.5m Manuel D'utilisation

Center of Gravity (CG)

The CG location is measured from the leading edge of the wing at the root.
(without slats installed)
• 60mm +/-5mm back from the leading edge
NOTICE: Install the battery but do not arm the ESC while checking the CG.
Personal injury may result.

AS3X Control Direction Test (BNF Basic)

®
This test ensures that the AS3X control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
CAUTION: Keep all body parts, hair and loose clothing away from a
moving propeller, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond as
shown, do not fl y the aircraft. Refer to the receiver manual for more information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.

In Flight Trimming (BNF Basic)

During your fi rst fl ight, trim the aircraft for level fl ight at 1/2 throttle with fl aps
up. Make small trim adjustments with your transmitter's trim switches to
straighten the aircraft's fl ight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This
allows the receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect fl ight performance.
Aircraft
AS3X Reaction
movement
3 Seconds
EN
60 +/-5mm
back from leading edge
of wing at the fuselage.
11