Installing Flight Battery; Center Of Gravity (Cg) - Horizon Hobby ParkZone F4F Wildcat BNF Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installing Flight Battery and Center of Gravity
Installing the Flight Battery
Note: After centering control surfaces with Control Direction
Test (pg 12) and before flying, rebind the aircraftt so the control
surfaces are neutral when plugging in the flight battery.
Note: If using a 1800–2200mAh LiPo pack rather than the 1300
mAh LiPo supplied with the Wildcat, a longer hook and loop
strap is supplied
CAUTION: Install receiver and connect the speed
control into the throttle channel (for PNP) before installing
the flight battery.
Note: Always power on transmitter before connecting battery.
1. Install the flight battery (PKZ1033) in the fuselage pocket in
the front of the fuselage.
2. Connect the battery to the ESC.
3. Secure the flight battery using the hook and loop straps.
4. Make sure wires in the fuselage do not block the canopy
hatch when closing the hatch.

Center of Gravity (CG)

/
The CG location is 1
in (47 mm) back from leading edge of the
7
8
wing at the root +/- 1/8 inch (3mm). This CG location has been
determined with the ParkZone 11.1V 1300mAh Li-Po battery
installed in the battery cavity.
EN
9

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Parkzone f4f wildcat pnpPkz1975Pkz1980

Table des Matières