Transmitter And Receiver Binding; Additional Binding Information - Horizon Hobby ParkZone F4F Wildcat BNF Manuel D'utilisation

EN

Transmitter and Receiver Binding

Binding is connecting a transmitter to an aircraft receiver wirelessly or electronically so the aircraft receiver recognizes the
transmitter GUID (Globally Unique Identifier) code. Binding is necessary for proper operation.
The F4F Wildcat requires a DSM2 full range (high power) transmitter. The list below is Spektrum™ or JR® DSM2-equipped full range
transmitters and modules that can bind to the F4F Wildcat's receiver:
•Spektrum DX5e •Spektrum DX6i
List is complete as of this printing. Additional compatible transmitters may be available.
Note: When using a Futaba transmitter with a Spektrum receiver, reversing the throttle channel may be required.
CAUTION: ALWAYS power on the transmitter before connecting the flight battery to the aircraft ESC. ALWAYS
disconnect the flight battery from the aircraft ESC before powering off the transmitter.

Additional Binding Information

Before each flight, power on the transmitter and wait about five (5) seconds
before connecting the flight battery to the aircraft ESC. The transmitter
scans and secures two radio frequencies for aircraft control. When the flight
battery is connected too quickly for the transmitter to make frequency
selection, the transmitter and receiver may not connect. When there is no
connection, leave the transmitter powered on, disconnect the flight battery
then connect the
flight battery to
the receiver.

1. Read transmitter instructions for binding to a receiver (location of transmitter's Bind control).
2. Make sure transmitter is powered off.
3. Install a bind plug in the receiver Batt/Bind port (if required and not already installed from the
factory).
4. Connect the flight battery to the ESC. The receiver LED will begin to flash rapidly.
5. Move the transmitter controls to neutral (flight controls: rudder, elevators and ailerons) or to low
positions (throttle, throttle trim, and flight control trims).*
6. Power on the transmitter while holding the transmitter bind button or switch. Refer to your
transmitter's manual for binding button or switch instructions.
7. The receiver light will go from flashing rapidly to flashing slowly. After 5–10 seconds the light will
become solid indicating the receiver is bound to the transmitter.
8. Remove the bind plug from the receiver.
9. Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part loops
and clips).
10. The receiver should keep the binding to the transmitter until a bind plug is put in the receiver Batt/
Bind port.
* The throttle will not arm if the transmitter's throttle control is not put at the lowest position.
If you encouner problems, obey binding instructions and refer to transmitter troubleshooting guide for
other instructions. If needed, contact the appropriate Horizon Product Support office.
6
•Spektrum DX7/DX7se •JR X9303/9503 2.4
Binding Procedure Reference Table
•JR 11X •JR 12X 2.4 •All SPM Module systems