General Binding Tips And Failsafe; Transmitter And Receiver Binding / Enable Or Disable Safe Select (Bnf Basic) - Horizon Hobby E-Flite Viper 90mm EDF Manuel D'utilisation

EN

General Binding Tips and Failsafe

• The included receiver has been specifically programmed for operation of this
aircraft. Refer to the receiver manual for correct setup if the receiver is replaced.
• Keep away from large metal objects while binding.
• Do not point the transmitter's antenna directly at the receiver while binding.
• The orange LED on the receiver will flash rapidly when the receiver enters bind
mode.

Transmitter and Receiver Binding / Enable or Disable SAFE Select (BNF Basic)

The BNF Basic version of this airplane includes SAFE Select technology, enabling you to choose the level of flight protection. SAFE mode includes angle limits and
automatic self leveling. AS3X mode provides the pilot with a direct response to the control sticks. SAFE Select is enabled or disabled during the bind process. With SAFE
Select disabled the aircraft is always in AS3X mode. With SAFE Select enabled the aircraft will be in SAFE Select mode all the time, or you can assign a switch to toggle
between SAFE Select and AS3X modes.
Thanks to SAFE Select technology, this aircraft can be configured for full-time SAFE mode, full-time AS3X mode, or mode selection can be assigned to a switch.
IMPORTANT: Before binding, read the transmitter setup section in this manual and complete the transmitter setup table to ensure your transmitter is properly
programmed for this aircraft.
IMPORTANT: Move the transmitter flight controls (rudder, elevators, and ailerons) and the throttle trim to neutral. Move the throttle to low before and during binding. This
process defines the failsafe settings.
You can use either the bind button on the receiver case OR a conventional bind plug to complete the binding and SAFE Select process.
SAFE can also be enabled via Forward Programming.
Using The Bind Button...
To Enable SAFE Select
Lower Throttle Connect Power
Orange Flashing LED Bind TX to RX
SAFE SELECT ENABLED: The control surfaces cycle back and forth twice
with a slight pause at neutral position every time the receiver is powered on.
To Disable SAFE Select
Lower Throttle Connect Power
Release Bind Button
Orange Flashing LED
SAFE SELECT DISABLED: The control surfaces cycle back and forth once
every time the receiver is powered on.
8
• Once bound, the receiver will retain its bind settings for that transmitter until
• If the receiver loses transmitter communication, the failsafe will activate.
• If problems occur, refer to the troubleshooting guide or if needed, contact the
Press and hold Bind Button
Release Bind Button
Press and hold Bind Button
Bind TX to RX
you re-bind.
Failsafe moves the throttle channel to low throttle. Pitch and roll channels move
to actively stabilize the aircraft in a descending turn.
appropriate Horizon Product Support office.
Using The Bind Plug...
To Enable SAFE Select
Install Bind Plug Lower Throttle
Orange Flashing LED Remove Bind Plug
SAFE SELECT ENABLED: The control surfaces cycle back and forth twice with a
slight pause at neutral position every time the receiver is powered on.
To Disable SAFE Select
Install Bind Plug Lower Throttle
Orange Flashing LED Bind TX to RX
SAFE SELECT DISABLED: The control surfaces cycle back and forth once
every time the receiver is powered on.
Viper 90mm EDF
Connect Power
Bind TX to RX
Connect Power
Remove Bind Plug