Dual Rates And Control Throws; As3X Control Response Test (Bnf Basic); In Flight Trimming (Bnf Basic) - Horizon Hobby E-Flite Viper 90mm EDF Manuel D'utilisation

Dual Rates and Control Throws

Program your transmitter to set the rates and control throws based on your
experience level. These values have been tested and are a good starting point to
achieve a successful first flight.
After flying, you may choose to adjust the values for the desired control response.

AS3X Control Response Test (BNF Basic)

This test ensures that the AS3X control system is functioning properly. Assemble
the aircraft and bind your transmitter to the receiver before performing this test.
1. Raise the throttle to any setting above 25%, then lower the throttle to activate
AS3X technology.
CAUTION: Keep all body parts, hair and loose clothing away from the fan
intake, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond as
shown, do not fly the aircraft. Refer to the receiver manual for more information.
Once the AS3X system is active, control surfaces may move rapidly. This is normal.
AS3X remains active until the battery is disconnected.

In Flight Trimming (BNF Basic)

During your first flight, trim the aircraft for level flight. Make small trim adjustments
with your transmitter's trim switches to straighten the aircraft's flight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This allows
the receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect flight performance.
Low Rate
11mm (7/16") p
Aileron
11mm (7/16") q
10mm (3/8") p
Elevator
10mm (3/8") q
Rudder
19mm (3/4") 
Aircraft movement
3 Seconds
EN
High Rate
16mm (5/8") p
16mm (5/8") q
14mm (9/16") p
14mm (9/16") q
25mm (1") 
AS3X Reaction
11