Transmitter And Receiver Binding; Control Tests - Horizon Hobby Blade Nano CPS Manuel D'utilisation

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need to 'bind' your chosen Spektrum
aircraft transmitter to the receiver for proper operation.
If you purchased an RTF model, the transmitter is bound to the model at the factory.
If for any reason you need to re-bind your Nano CPS to the MLP6DSM, follow the directions below:
Binding Procedure for the MLP6DSM (RTF)
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.
4. Push and hold the "panic" trigger/button and hold the rudder control stick to full left while powering on the trans-
mitter.
5. Release the trainer switch/button. Continue to hold the rudder control stick to full left until the blue LED on the
3-in-1 control unit is solid.
6. Release the rudder control stick.
7. Push the trainer switch/button. The blue LED on the 3-in-1 control unit fl ashes to confi rm the helicopter
is in non-computer mode.
8. Disconnect the fl ight battery and power the transmitter off.
NOTICE: If the swashplate moves up and down when the trainer switch is moved, the helicopter is in computer
transmitter mode. Repeat the binding procedure.
To bind your Nano CPS to your chosen transmitter, follow the directions below:
Binding Procedure for Computer Radios (BNF)
1. Disconnect the fl ight battery from the helicopter.
2. Power off the transmitter and move all switches to the 0 position.
3. Connect the fl ight battery to the helicopter. The 3-in-1 Control unit LED fl ashes after 5 seconds.
4. Push the bind switch/button while powering on the transmitter.
5. After 2–3 seconds, release the bind switch/button.
6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right
until the blue LED on the 3-in-1 control unit is solid.
7. Release the rudder control stick.
8. Disconnect the fl ight battery and power the transmitter off.
NOTICE: The throttle will not arm if the transmitter's throttle control is not put at the lowest position and the stunt
mode switch is not in the 0 position.
If you encounter problems, refer to the troubleshooting guide for other instructions. If needed, contact the appropriate
Horizon Hobby Product Support offi ce.

Control Tests

Ensure the throttle hold is ON when doing the direction
control tests. Test the controls prior to the fi rst fl ight to
ensure the servos, linkages and parts operate correctly.
Elevator
Elevator down
EN
If the controls do not react as shown in the illustrations
below, confi rm the transmitter is programmed correctly.
Left Side View
Elevator up
8
™ DSM2 ® / DSMX ® technology equipped
Left Side View