Transmitter Control (Rtf); Installing The Flight Battery - Horizon Hobby Blade Nano CPS Manuel D'utilisation

Transmitter Control (RTF)

Flight mode
switch
Bind switch
H H
G
F
When pressed down, trim buttons make a sound that increases or decreases in pitch at each pressing. The middle or
neutral trim position is heard as a middle tone in the pitch range of the sounds. The end of the control range is sounded
by a series of beeps.
A
Power LED/
Mode 1 fl ight mode
indicator
Power LED/
Mode 2 fl ight mode
indicator
Dual Rate Selection
The control sensitivity can be changed by pressing and releasing the right control stick. The LED on the transmitter will show
solid for high sensitivity (default) and fl ashing for low sensitivity.

Installing the Flight Battery

1. Lower the throttle and throttle trim to the lowest set-
tings.
2. Power on the transmitter.
3. Install the fl ight battery in the battery holder. Connect
the battery cable to the 3-in-1 control unit.
NOTICE: Do not allow the helicopter to move until the
blue LED on the 3-in-1 control unit is solid.
NOTICE: Always disconnect the Li-Po battery from the
3-in-1 control unit of the aircraft when not fl ying. Failure
to do so may result in over discharge.
B C
Aileron (Left/Right) Throttle
Throttle (Up/Down) Trim
Aileron (Left/Right) Elevator
Elevator (Up/Down) Trim
A
E
D E
Aileron ON/OFF Rudder
Trim Switch Trim
Aileron ON/OFF Rudder
Trim Switch Trim
7
Panic Pa
Recovery R
Dual rate switch
B B
C
D
F G
Elevator Rudder (Left/Right)
Trim Elevator (Up/Down)
Throttle Rudder (Left/Right)
Trim Throttle (Up/Down)
H
EN