Transmitter And Receiver Binding; Low Voltage Cutoff (Lvc) - Horizon Hobby Bind-N-Fly UMX PT-17 Manuel D'utilisation

Transmitter and Receiver Binding

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er)
code of a single specifi c transmitter. You need to 'bind' your chosen Spektrum
equipped aircraft transmitter to the receiver for proper operation.
Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. Please visit www.
bindnfl y.com for a complete list of compatible transmitters.

Binding Procedure
CAUTION: When using a Futaba transmitter with a Spektrum DSM
throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe
instructions. Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.
1. Refer to your transmitter's unique instructions for binding to a receiver (location of transmitter's
Bind control).
2. Make sure the fl ight battery is disconnected from the aircraft.
3. Power off your transmitter.
4. Connect the fl ight battery in the aircraft. The receiver LED will begin to fl ash rapidly (typically after
5 seconds).
5. Make sure the transmitter controls are neutral and the throttle and throttle trim are in low position.
6. Put your transmitter into bind mode. Refer to your transmitter's manual for binding button or
switch instructions.
7. After 5 to 10 seconds, the receiver status LED will turn solid, indicating that the receiver is bound
to the transmitter. If the LED does not turn solid, refer to the Troubleshooting Guide at the back of
the manual.

Low Voltage Cutoff (LVC)

When a Li-Po battery is discharged below 3V per
cell, it will not hold a charge. The aircraft's ESC
protects the fl ight battery from over-discharge
using Low Voltage Cutoff (LVC). Once the battery
discharges to 3V per cell, the LVC will reduce the
power to the motor in order to leave adequate
power to the receiver and servos to land the
airplane.
When the motor power decreases, land the aircraft
immediately and replace or recharge the fl ight
battery.
Always disconnect and remove the Li-Po battery
All manuals and user guides at all-guides.com
from the aircraft after each fl ight. Charge your Li-Po
battery to about half capacity before storage. Make
sure the battery charge does not fall below 3V per
cell. Failure to unplug a connected battery will result
in trickle discharge.
For your fi rst fl ights, set your transmitter timer or a
stopwatch to 5 minutes. Adjust your timer for longer
or shorter fl ights once you have fl own the model.
NOTICE: Repeated fl ying to LVC will damage the
battery.
™
DSM2/DSMX technology
® module, you must reverse the
EN
5