Installing The Flight Battery; Transmitter And Receiver Binding - Horizon Hobby Blade Fusion 360 Manuel D'utilisation

Installing the Flight Battery

1. Lower the throttle.
2. Power on the transmitter.
3. Center all trims.
4. To allow the ESC to arm and to keep rotors from
initiating at startup, turn on throttle hold and normal
fl ight mode before connecting the fl ight battery.
5. Attach hook material to the helicopter frame and loop
material to the battery.
6. Install the fl ight battery on the helicopter frame. Secure
the fl ight battery with a hook and loop strap. Connect
the battery cable to the ESC.
CAUTION: Make sure the fl ight battery, wire and
connector does not come into contact with the
motor. Failure to do so will cause the motor, ESC and
battery to overheat, resulting in a crash causing property
damage and injury.

Transmitter and Receiver Binding

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifi er) code of a single
specifi c transmitter. You need to 'bind' your chosen Spektrum
to the receiver for proper operation.
Binding Procedure
1. Program your transmitter using the Transmitter Setup found in this manual.
2. Insert the bind plug in the BIND port on the wiring harness between the fl ight controller and the receiver.
3. Connect the fl ight battery to the ESC. The orange LED on the receiver will begin fl ashing rapidly to indicate bind mode.
4. Move the throttle stick to the low throttle position in normal mode.
5. Follow the procedures of your specifi c transmitter to enter bind mode. The system will connect within a few seconds.
Once connected, the orange LED on the receiver will come on solid orange.
6. Disconnect the fl ight battery and remove the bind plug. Store the bind plug in a convenient place.
NOTICE: Remove the bind plug to prevent the system from entering bind mode the next time the power is turned on.
CAUTION: When using a Futaba
If you encounter problems, obey binding instructions and refer to transmitter troubleshooting guide for other instructions.
If needed, contact the appropriate Horizon Product Support offi ce.
™
®
transmitter with a Spektrum
7
7. Do not move the helicopter until the fl ight controller
initializes. The swashplate will center, indicating that
the unit is ready. The fl ight controller status LED will
display a slow green fl ash once initialization has been
completed.
8. The helicopter motor will emit a series of tones,
indicating the ESC is armed.
CAUTION: Always disconnect the Li-Po battery
from the ESC power lead when not fl ying to avoid
over-discharging the battery. Batteries discharged below
the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when
batteries are charged.
® ®
DSM2 /DSMX technology equipped aircraft transmitter
™ ®
DSM2 module, you must reverse the throttle channel.
EN