Advanced Tuning (Forward Programming); Factory Reset - Horizon Hobby Blade Fusion 360 Manuel D'utilisation

Advanced Tuning (Forward Programming)

Applies to forward programming capable Spektrum Transmitters including
DX6G2, DX7G2, DX8G2, DX9, iX12, DX18, DX20
The Fusion 360 default settings are appropriate for most users. We recommend fl ying with the default parameters before
making any adjustments.
The Fusion 360 BNF fl ight controller may be programmed from any compatible Spektrum transmitter
(visit SpektrumRC.com for more information).
The fl ight controller shipped with BNF models has a range of adjustable parameters suitable for the Fusion 360 Helicopter
and is not intended for use in other aircraft.
It is important to use the included servos with the BNF fl ight controller because the adjustable parameters available for
the SPMAR6250HX are designed around the recommended servos. It is possible there may not be enough range for the
helicopter to be tuned when using alternative servos.
Entering the Advanced Parameters Men
With the helicopter bound to the transmitter and powered on, enter the Function List and select Forward Programming.
The list of adjustable parameters and the range of values available for tuning have been tailored for this helicopter. Make
small changes to one parameter at a time and test fl y the changes before changing the parameter further or changing a
different parameter.
Calibration Procedure
If the helicopter is experiencing drift issues, perform the following calibration. The calibration procedure may also be
needed following crash repairs.
1. Ensure the surface used for calibration is level.
2. Power on the transmitter and activate throttle hold.
3. Connect the fl ight batter to the ESC and allowing the
model to initialize.
4. Turn Throttle Hold ON.
5. Using a bubble level as shown below, level the
helicopter by placing a shim under the landing skid.
6. Enter the Function List on your transmitter.
7. Select Forward Programming.

Factory Reset

If the process of tuning the Fusion 360 helicopter results in undesirable fl ight performance, you can reset the settings
back to factory defaults by selecting the Factory Reset option in Forward Programming.
1. Enter the Function List
2. Select Forward Programming
3. Select System Setup
4. Select Factory Reset
u
:
Bubble level
Shim
8. Select System Setup.
9. Select Calibration.
10. Select Apply and the calibration will begin. The
LED will fl ash yellow indicating the calibration is
proceeding normally. If the LED changes to red this
indicates the model is not near level or the model was
moved, in this case the calibration starts over.
11. After the calibration is successfully completed, the
receiver LED will will change to a slow green fl ash
which indicates the calibration has completed.
12. Proceed to the pre-fl ight check list procedure before
fl ying your model.
5. Select Apply
6. Perform the Setup->Swashplate->Sub Trim function
and ensure the servos are properly trimmed.
7. Proceed with the pre-fl ight check list procedure
before fl ying the model.
11
EN