First Flight Preparation; Flying Checklist; Programming Your Transmitter - Horizon Hobby Blade Red Bull BO-105 CB 130 X Manuel D'utilisation

First Flight Preparation

• Remove and inspect the box contents
• Charge the fl ight battery
• Program your computer transmitter
• Install the fully charged fl ight battery in the helicopter
• Bind your transmitter to the helicopter
• Familiarize yourself with the fl ight controls
• Find an open area for fl ying

Programming Your Transmitter

Program your transmitter before attempting to bind or fl y the helicopter. Transmitter programming values are shown
below for the Spektrum DX6i, DX7/DX7se, DX7s and DX8. The Spektrum model fi les for transmitters with AirWare™
software are also available for download online in the Spektrum Community.
NOTICE: When using a Futaba
rebind. Refer to your Spektrum module manual for binding and failsafe instructions. Refer to your Futaba transmitter
manual for instructions on reversing the throttle channel.
DX6I
SETUP LIST
Model Type
HELI
Reverse
THRO N
AILE
ELEV
RUDD N
GYRO N
PITC
Swash Type
1 Servo 90
Timer
TYPE
TIME
SWITCH TRAINER
Gyro
INHIBIT
Swash Mix
INHIBIT
®
transmitter with a Spektrum DSM
ADJUST LIST
D/R & Expo
0-AILE
0-ELEV
0-RUDD
1-AILE
N
1-ELEV
N
1-RUDD
Thro Curve
NORM
R
STUNT
HOLD
Pitc Curve
NORM
DOWN
STUNT
3:00
HOLD
Travel Adj
THRO
AILE
ELEV
RUDD
GYRO
PITC

Flying Checklist

❏ Always turn the transmitter on fi rst
❏ Plug the fl ight battery into the lead from the
fl ybarless unit
❏ Allow the fl ybarless unit to initialize and arm properly
❏ Fly the model
❏ Land the model
❏ Unplug the fl ight battery from the fl ybarless unit
❏ Always turn the transmitter off last
®
module, you must reverse the throttle channel and
100% 40%
100% 40%
100% INH
85% 40%
85% 40%
85% INH
0% 40% 60%
100% 100% 100% 100% 100%
10% 10% 10%
30% 40% 50%
0% 25% 50%
0% 25% 50%
Sub-Trim*
100% 0
100% 0
100% 0
100% 0
100% 0
100% 0
5
68% 75%
10% 10%
75% 100%
75% 100%
75% 100%
EN