Model Assembly; Landing Gear Installation - Horizon Hobby E-flite Turbo Timber 1.5m Manuel D'utilisation

Model Assembly

Landing Gear Installation

Mount the Landing Gear to the Fuselage
1. Insert one landing gear assembly into the pocket
on the side of the fuselage as shown. The landing
gear legs mount to the aluminum block which can pivot
in the pocket.
2. Thread the included 3 x 8mm machine screws
through the landing gear leg into the threaded
holes in the aluminum pivot block.
3. Repeat the process to install the second
landing gear assembly.
Mount the Spring Assemblies to the Fuselage
1. Align the spring assemblies with the mounting holes in the fuselage. These
assemblies mount to the plastic bracket pre-installed in the fuselage
between the landing gear.
2. Install the two 3 x 10mm self tapping screws to anchor the spring
assemblies in place.
Clamp the Spring Assemblies Together
1. Align the spring assemblies with the joiner bracket
2. Clamp the assembly together with the two 2 x 6mm self tapping screws.
3 x 10mm
self-tapping
button head
EN
3 x 8mm
button head
machine
2 x 6mm
self-tapping
button head
5