Wing Assembly - Horizon Hobby E-flite Turbo Timber 1.5m Manuel D'utilisation

Model Assembly Continued

Wing Assembly

Required Adhesives
Medium CA
Slat Installation (Optional)
1. Carefully remove all the foam slat pocket covers (A) from the wing.
2. When the pocket is exposed, carefully apply medium CA to each slat pocket.
3. Mount the slat onto the wing with the rounded edge facing forward. Ensure
that the left and right slats are on the correct wing half. The slat and wing
halves are labeled with "L" and "R" indicators.
Wing Assembly
1. Insert the wing joiner tube and slide the left and right wing halves together, as shown.
2. Secure the wing together using the wing bracket (A).
3. Guide the Flaps, Lights and Aileron servo connectors (B) into the top of the
fuselage as shown.
Tip: If needed, use hemostats or pliers to pull the servo connectors into the fuselage.
4. Connect the Flaps, and Aileron connectors to respective
Y-harnesses connected to the receiver. The left and right servos
can be connected to either side of a Y-harness.
5. Connect the two light connectors (with exposed pins) to the light harness.
IMPORTANT: The ailerons must be connected to the receiver's aileron port
(channel 2) with a Y-harness (included) for the AS3X
6. Align the wing with the fuselage and secure into position using the included
2 nylon wing bolts (C).
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
Disassemble in reverse order. emble in reverse order.
@ system to function properly.
Flaps
Lights
Ailerons
A
C
A
B
EN
7