Model Assembly; Propeller Installation - Horizon Hobby E-FLITE P-47 Thunderbolt Manuel D'utilisation

Model Assembly

Propeller Installation

IMPORTANT: It is recommended to install the propeller after all system setups
are completed to reduce the chance of accidental propeller strike.
1. Use a tool to remove the spinner (A) from the collet (B).
2. Install the propeller with the size numbers (9.8 x 6) facing out from
the motor.
3. Use a tool to re-install the spinner and secure the propeller in place.
Horizontal Tail Installation
1. Slide the horizontal tail tube (A) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the con-
trol horn faces down.
3. Apply 4 pieces of tape (B) (included) to secure the two horizontal tail pieces
in place.
4. Attach the clevis to the elevator control horn (see instructions for
clevis connection).
B
A
A
B
EN
5