Pnp Receiver Selection And Installation - Horizon Hobby E-flite A-10 Thunderbolt II 64mm Twin EDF Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Optional Scale Ordnance Installation
The included optional scale ordnance are easily installed and removed without
the use of tools.
A: The Mk. 84 Bombs are installed on the innermost wing mounting points.
B: The AGM-65 Maverick Missiles are installed on the fi rst mounting points
outside the landing gear sponson.
C: The LAU-131 Rocket Pods are installed on the middle mounting points of
the outer wing panel.
D: The AIM-9 Sidewinder Missiles are installed on the outermost wing
mounting points.
To install the missiles:
1. Insert the tabs of the missiles in the enlarged end of the mounting
point slots.
2. Slide toward the back of the aircraft to lock the tabs in the slots.
TIP: There is a left and right to each pylon. The notation can be found on the
base of the pylon.
To remove the missiles, slide them forward and pull the tabs out of the
mounting slots.

PNP Receiver Selection and Installation

The recommended receiver for this aircraft is the Spektrum AR636. If you
choose to install a different receiver, ensure that it is at least a 6-channel full
range (sport) receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR636 Installation
1. Pull open the receiver hatch (A) to expose the receiver compartment. The
hatch is held in place magnetically.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the table at the right.
3. Using double-sided servo tape, (not included) mount the receiver to the
fl at area in the receiver compartment located on the bottom side of the
fuselage, as shown. The receiver should be mounted in the orientation
shown, parallel to the length of the fuselage, with the label facing up and
the servo ports facing the rear of the aircraft. The orientation of the receiver
®
is critical for all AS3X
and SAFE
NOTICE: You must set the orientation of the receiver using the Spektrum
programming software.
CAUTION: Incorrect installation of the receiver could cause a crash.
®
technology setups.
A
A
B
C
D
A
EN
D
B
C
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder/Nose Wheel
5 = Retracts
6 = Flaps
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

E-flite efl01150E-flite efl01175

Table des Matières