Pnp Receiver Selection And Installation - Horizon Hobby E-Flite EFL FW 190A 1.5m BNF Basic Manuel D'utilisation

EN

PNP Receiver Selection and Installation

The recommended receiver for this aircraft is the Spektrum AR637T. If you
choose to install a different receiver, ensure that it is at least a 6-channel
full range receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR637T Installation
1. Slide the canopy latch (A) back and lift the back of the canopy to remove
the canopy from the fuselage.
2. Attach the appropriate control surfaces to the their respective ports on the
receiver using the table at the right.
3. Using double-sided servo tape (not included), mount the receiver to
the flat area behind the battery compartment, as shown. The receiver
should be mounted in the orientation shown, parallel to the length of the
fuselage, with the label facing up and the servo ports facing the front of the
aircraft. The orientation of the receiver is critical for all AS3X
technology setups.
CAUTION: Incorrect installation of the receiver could cause a crash.
8
AR637T Port
Assignments
BND/PRG = BIND
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder
5 = Retracts
6 = Flaps
B
and SAFE
® ®
A
Fw 190A 1.5m