Post Flight; Motor Service; Troubleshooting Guide As3X - Horizon Hobby E-Flite EFL FW 190A 1.5m BNF Basic Manuel D'utilisation

EN

Post Flight

Disconnect the flight battery from the ESC (Required for Safety and
1
battery life).
2 Power OFF the transmitter.
3 Remove the flight battery from the aircraft.
4 Recharge the flight battery.

Motor Service

CAUTION: Always disconnect the flight battery before performing
motor service.
Disassembly
1. Remove the screw (A) and spinner (B) from the prop shaft (C).
2. Remove the prop nut (D) and prop washer (E).
3. Remove the propellers (F), cooling fan (G) backplate (H) from the prop shaft.
4. Remove the 4 screws (I) from the prop shaft and remove from motor shaft.
5. Disconnect the motor wires from the ESC wires.
6. Remove the 4 screws (J) and motor (K) from the motor mount.
7. Remove the 4 screws (L) from the motor to remove the X-mount.
Assembly
Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Tighten the prop nut by using a wrench

Troubleshooting Guide AS3X

Problem
Damaged propeller or spinner
Imbalanced propeller
Motor vibration
Oscillation Loose receiver
Loose aircraft controls
Worn parts
Irregular servo movement
Trim is not at neutral
Inconsistent flight Sub-Trim is not at neutral
performance
Aircraft was not kept immobile for
5 seconds after battery connection
Incorrect response
Incorrect direction settings in the
to the AS3X Control
receiver, which can cause a crash
Direction Test
16
Possible Cause
Replace propeller or spinner
Balance the propeller.
Replace parts or correctly align all parts and tighten fasteners as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)
Replace worn parts (especially propeller, spinner or servo)
Replace servo
If you adjust trim more than 8 clicks, adjust the clevis to remove trim
No Sub-Trim is allowed. Adjust the servo linkage
With the throttle stick in lowest position. Disconnect battery, then reconnect battery and keep the
aircraft still for 5 seconds
DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly
5 Repair or replace all damaged parts.
Store the flight battery apart from the aircraft and monitor the battery
6
charge.
Make note of the flight conditions and flight plan results, planning for
7
future flights.
F
E
D
B
A
L
J
I
Solution
Fw 190A 1.5m
C
G
H
K
Wiring not shown