Low Voltage Cutoff (Lvc); Post Flight; Post Flight Checklist - Horizon Hobby Conscendo S Manuel D'utilisation

EN

Low Voltage Cutoff (LVC)

LVC is a mechanism built into your ESC to protect the
battery from over-discharge. When the battery charge
is too low, LVC limits power supplied to the motor. The
aircraft will begin to slow and you will hear the motor
pulse. When the motor power decreases, land the aircraft
immediately and recharge the fl ight battery.
Disconnect and remove the Li-Po battery from the aircraft
after use to prevent trickle discharge. Charge your Li-Po
battery to about half capacity before storage. During
storage, make sure the battery charge does not fall below
3V per cell.
Prolong the life of your Battery
• Before storage, charge your battery to about half
capacity. Capacity decreases with use and age.
• During storage, ensure the charge does not fall below
3V per cell.
Landing
Land the aircraft in Beginner mode.
Easy Landing
Landing is easier if you hold the Panic Recovery but-
ton. Line up for your landing, decrease the throttle
to 0% and press and hold
the Panic Recovery button.
The aircraft will glide down
wings level with the nose
up (fl ared) for landing.
NOTICE: If a crash is im-
minent, reduce the throttle.
Failure to do so could result in
extra damage to the airframe,
as well as damage to the
receiver and motor.
NOTICE: Crash damage is not
covered under warranty.
CAUTION: Never catch a fl ying aircraft in your
hands. Doing so could cause personal injury and
damage to the aircraft.
Important! Due to the effi cient nature of the
Conscendo S, the airplane can be diffi cult to land in
a small area. Plan the landing to allow enough room
for approach and allow space if the airplane does
not descend as fast as intended.
®
Conscendo
CH 5
Always
decrease throttle at
propeller strike.
™
S
NOTICE: Repeated fl ying to LVC will damage the battery.
Descends at 0% throttle

Post Flight

NOTICE: When you are fi nished fl ying, never leave the aircraft in direct
sunlight or in a hot, enclosed area such as a car. Doing so can damage the
foam.

Post Flight Checklist

1. Disconnect fl ight battery from the aircraft. (Required for
Safety)
2. Remove fl ight battery from the aircraft.
3. Power off transmitter.
4. Recharge fl ight battery.
5. Repair or replace all damaged parts.
6. Store fl ight battery apart from the aircraft and monitor the
battery charge.
7. Make note of fl ight conditions and fl ight plan results,
planning for future fl ights.
16
Wind 0–7 mph
(0–11km/h)