Transmitter Setup - Horizon Hobby Conscendo S Manuel D'utilisation

Transmitter Setup

IMPORTANT: The included AR636 receiver has been
programmed for operation specifi cally in this aircraft.
The programming in this receiver cannot be changed
by the user.
To operate the SAFE system in this aircraft, set up
your optional DSM2/DSMX transmitter using the chart
below.
- SAFE Flight mode is selected using Channel 5
signal (high, middle, low)
- Panic Recovery mode is selected with Channel 6
signal (high, low)
IMPORTANT: A transmitter with a 2-position Channel
5 switch will only allow the use of position 0 or posi-
tion 2 fl ight modes. If possible (refer to your transmit-
ter manual), assign Channel 5 in your transmitter to a
3-position switch to operate all 3 fl ight modes.
Refer to your transmitter's manual for more informa-
tion about transmitter setup.
™
Conscendo S
Non Computerized Transmitter Setup
Transmitter
Throttle, Aileron, Elevator and Rudder in Normal Position
DX5e
(2pos switch)
DX5e
(3pos switch)
Computerized Transmitter Setup
(DX6i, DX6, DX7, DX7S, DX8, DX9 and DX18)
Start all transmitter programming with a blank model (do a model reset), then name the
model.
Set Dual Rates to:
1. Go to the SETUP LIST MENU
DX6i
2. Set MODELTYPE: ACRO
3. Set REVERSE: Gear Channel
4. Go to ADJUST LIST MENU
5. Set TRAVEL ADJ: Gear/Fmode (0) 100%; Gear/Fmode (1)
6. Set FLAPS: Norm
7. Set MIX 1: ACT; Gear
TRIM INH
Resulting in:
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLAN
DX7S
3. Set SWITCH SELECT: Change all to INH then TRAINER: AUX1, FLAP:
DX8
GEAR
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Resulting in:
1. Go to the SYSTEM SETUP
DX6
2. Set MODEL TYPE: AIRPLANE
DX7
3. Set CHANNEL ASSIGN:
DX9
click NEXT to go to Channel Input Confi g:
DX18
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Resulting in:
5
SAFE mode switch SAFE Flight Modes Supported
CH 5 switch 2 Pos Flight Mode
CH 5 switch 3 Pos Flight Mode
HIGH 100%
LOW 70%
100; LAND 100
Gear ACT, RATE D 0%; U + 100%, SW MIX,
The Gear and Mix switches operate the 3 SAFE modes
Gear 0; Mix 0 = Beginner Mode
Gear 1; Mix 0 = Intermediate Mode
Gear 1; Mix 1 = Experienced Mode
The Flap switch operates Panic Recovery:
Position 0=Off, Position 1=On. (not a momentary
switch)
Flap/Gyro Switch operates the 3 SAFE modes
-0 Beginner
-1 Intermediate
-2 Experienced
The Trainer/Bind button operates Panic Recovery
GEAR: B, AUX1: i
Switch B operates the 3 SAFE modes
-0 Beginner
-1 Intermediate
-2 Experienced
The Bind/I button operates Panic Recovery
EN
(DX5e)
40%
RTF