Range Test; Prefl Ight Checklist - Horizon Hobby Conscendo S Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Range Test

Before each fl ying session, and especially with a new
model, you should perform a range check. The DX4e
incorporates a range testing system. Placing the trans-
mitter in RANGE CHECK mode reduces the output power,
allowing a range check.
1. Power on the transmitter for 5 seconds or more with
the throttle stick and trim low. Plug in the aircraft bat-
tery and keep the aircraft immobile for 5 seconds.
2. Face the model with the transmitter in your normal
fl ying position. Push and hold the BIND/Panic
button while toggling the HI/LO Rate switch four
times. The LEDs will fl ash and the alarm will sound.
The system is in range check mode.
IMPORTANT: You must hold the BIND/Panic button during
the entire range check process. Releasing the button will
exit the range check mode.
3. With the system powered on and the model restrained
on the ground*, stand 28 meters (90 feet) away from
the model.
CAUTION: In some aircraft, when the model is placed
on the ground, the antenna(s) can be within inches
of the ground. Close proximity of the antenna(s) to
the ground can reduce the effectiveness of the range
check. If you experience issues during the range
check, restrain the model on a non-conductive stand
or table up to 2ft (60cm) above the ground, then
range check the system again.
4. Move the transmitter rudder, elevator, aileron and
throttle controls to ensure they operate smoothly at
28 meters (90 feet).
5. If control issues exist, do not attempt to fl y. Refer
to the contact table at the end of the this manual to
contact Horizon Hobby product support. Also, see the
Spektrum website for more information.
Prefl ight Checklist
1.
Find a safe and open area.
2.
Charge fl ight battery.
3.
Install fully charged fl ight battery in aircraft.
4.
Make sure linkages move freely.
5.
Perform Control Direction Test.
6.
Perform SAFE Control Direction Test.
7.
Perform a Range Check.
8.
Plan fl ight for fl ying fi eld conditions.
9.
Set a fl ight timer for 8-10 Min.
10. Have fun!
Conscendo
S
1
2
3
CAUTION: While holding the aircraft during the Range Test, always keep
body parts and loose items away from the propeller. Failure to do so could cause
personal injury.
13
EN
Keep upright, im-
mobile and out of
the wind for
5 seconds
1
3
2
4
RTF

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hbz8600Hbz8680

Table des Matières