Assembly - Horizon Hobby Conscendo S Manuel D'utilisation

Assembly

Installing the Tail
1. Slide the horizontal stabilizer tube (A) into the hole in
the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal stabilizer
as shown. Ensure the control horn faces down.
3. Secure the 2 piece tail in place with the 2 included
pieces of tape (B). Install a piece of tape on the top
and bottom of each horizontal tail section as shown.
Attaching the Clevis to the
Control Horn
Finish the installation of the tail by connecting the control
rod with the clevis on the tail control horn under the
elevator.
1. Open the clevis and put the pin in the outermost hole
(A) of the control horn.
2. If needed, remove the clevis from the control horn.
- Turn the clevis (as shown) on the control rod (also
called a pushrod).
- Close the clevis onto the control horn and slide the
tube towards the horn to secure the clevis.
Wing Installation
Wing Assembly
1. Slide the left and right wing halves over the wing tube
(A) as shown.
2. Secure the wing halves together with the wing
bracket (B).
™
Conscendo S
1
A
1
Clevis
A
1
A
7
2
B
2
Control
Horn
2
EN
B
RTF