Trouble Shooting Guide - Horizon Hobby Conscendo S Manuel D'utilisation

EN

Trouble Shooting Guide

Problem
Loose or damaged propeller, shaft or motor
Loose receiver
Aircraft oscillates
Loose aircraft controls
Worn parts
Trim is at extreme and
aircraft does not fl y Trim is not at neutral
straight or level
Trim change when
fl ight mode is Receiver did not save trim setting
switched
Throttle not at lowest position or throttle trim too
Aircraft will not re-
high
spond to throttle but
responds to other Throttle channel is reversed
controls
Motor disconnected from Receiver/ESC
Damaged propeller, shaft or motor
Extra propeller noise
or extra vibration
Propeller is out of balance
Flight battery charge is low
Reduced fl ight time or
Flight battery damaged
aircraft underpowered
Flight conditions may be too cold
Transmitter too near aircraft during
binding process
Aircraft or transmitter is too close to large metal
Aircraft will not Bind
object, wireless source or another transmitter
(during binding) to
transmitter.
Flight battery/transmitter battery charge is too low
Refer to the transmit-
ter manual for binding
The bind plug is not installed correctly in the bind
instructions
port
Bind switch or button not held long enough during
bind process
Transmitter too near aircraft during
connecting process
Aircraft or transmitter is too close to large metal
Aircraft will not
object, wireless source or another transmitter
connect (after binding)
to transmitter
Refer to the transmit- Bind plug left installed in bind port
ter manual for binding
instructions
Flight battery/Transmitter battery charge is too low
Transmitter may have been bound to a
different aircraft using different DSM protocol
Control surface, control horn, linkage or servo
damage
Control surface does
Wire damaged or connections loose
not move
Flight battery charge is low
Receiver is damaged
Controls reversed Transmitter settings are reversed
Normal Low Voltage Cutoff (LVC)
Motor power pulses
Weather conditions might be too cold
then motor loses
Battery is old, worn out, or damaged
power
Battery C rating might be too small
®
Conscendo
Possible Cause
™
S
Replace parts or correctly align all parts and tighten fasteners
as needed
Align and secure receiver in fuselage
Tighten or otherwise secure parts (servo, arm, linkage, horn and control
surface)
Replace worn parts (especially propeller, spinner or servo)
If you need to adjust trim more than 8 clicks, return the trim to neutral and
manually adjust the clevis to mechanically remove trim
After adjusting transmitter trim in the air or on the ground, do not touch the
control sticks for 2 seconds
Reset controls with throttle stick and throttle trim at lowest
setting
Reverse throttle channel on transmitter
Make sure motor is connected to the Receiver/ESC
Replace damaged parts
Balance or replace propeller
Completely recharge fl ight battery
Replace fl ight battery and follow fl ight battery instructions
Make sure battery is warm before use
Move powered transmitter a few feet from aircraft, disconnect and reconnect
fl ight battery to aircraft
Move aircraft and transmitter to another location and attempt binding again
Replace/recharge batteries
Install bind plug in bind port and bind the aircraft to the transmitter
Power off transmitter and repeat bind process. Hold transmitter bind button or
switch until receiver is bound
Move powered transmitter a few feet from aircraft, disconnect and reconnect
fl ight battery to aircraft
Move aircraft and transmitter to another location and attempt
connecting again
Rebind transmitter to the aircraft and remove the bind plug before cycling
power
Replace/recharge batteries
Bind aircraft to transmitter
Replace or repair damaged parts and adjust controls
Do a check of wires and connections, connect or replace as needed
Fully recharge fl ight battery
Replace Receiver
Perform the Control Direction Test and adjust the controls on transmitter ap-
propriately
Recharge fl ight battery or replace battery that is no longer performing
Postpone flight until weather is warmer
Replace battery
Use recommended battery
18
Solution