Confirming Control Test Directions - Horizon Hobby BNF BLADE 500 X Manuel D'utilisation

Confirming Control Test Directions

Rudder and Cyclic Gyro Test
WARNING: Disconnect the motor from the ESC before performing Rudder and Cyclic Control Tests. Failure to disconnect the motor from the ESC may
cause the rotor blades to spin.
Rudder Gyro Test
1. Power on the transmitter.
2. Turn throttle hold ON and move the flight mode switch to select Normal
flight mode.
3. Connect the Li-Po battery to the ESC.
NOTICE: Do not allow the helicopter to move until the Status LED is solid
blue and all menu LEDs are OFF. The gyro will not operate correctly if the
helicopter moves before the Status LED is solid blue.
4. Move the rudder stick to the right. The tail rotor blades move as shown.
If they do not move as shown, reverse the rudder channel in your trans-
mitter.
Cyclic Gyro Test
When using a flybarless system, you are controlling rotational rates while
the AR7200BX controls the servos. You are not directly controlling the
ail
servos with the transmitter.
It is normal for the swashplate to slowly move back to its original
position after a stick input and for the servos to not move at the same
speed as your control sticks.
1. Tilt the helicopter forward. The swashplate should tilt backward.
CAUTION: You must complete the Rudder and Cyclic tests prior to flight. Failure to confirm the sensor directions are correct can cause the helicopter to
crash, resulting in property damage and/or injury.
ail
Cyclic and Collective Control Test
Turn ON Throttle Hold and Normal flight mode when performing the control tests.
Elevator
ail
Aileron
ail
ail
Collective Pitch
ail
All manuals and user guides at all-guides.com
Side View
Rear View
Rear View
5. Release the rudder control.
6. Manually turn the helicopter nose
to the left. The tail rotor blades
automatically move as shown. If
they do not move as shown, reverse
the AR7200BX tail sensor direc-
tion (Setup menu point F). See the
AR7200BX instruction manual for
more information.
2. Tilt the helicopter backward. The swashplate should tilt forward.
3. Roll the helicopter left. The swashplate should roll right.
4. Roll the helicopter right. The swashplate should roll left.
5. If the swashplate does not move in the correct direction, you will need to
reverse the cyclic sensor direction. Refer to the AR7200BX manual for
more information (Setup menu point M).
6. Disconnect the flight battery from the ESC.
7. Power the transmitter OFF.
8. Connect the motor wires to the ESC.
MODE 2
9
Side View
Rear View
Rear View
MODE 1
EN