Ar7200Bx Default Blade 500 X Setup - Horizon Hobby BNF BLADE 500 X Manuel D'utilisation

AR7200BX Default Blade 500 X Setup

SETUP MENU Menu LED solid
Status-LED:
A Mounting orientation
B Swashplate servo - frequency
Tail servo - center position pulse
C
length
D Tail servo - frequency
E Tail servo - rotor endpoints
F Tail - sensor direction
G Swashplate - servo centering
H Swashplate - mixer
I Swashplate - servo directions
Swashplate - cyclic pitch
J
geometry
K Collective pitch range
L Swashplate - cyclic limit
M Swashplate - sensor directions
N Pirouette optimization direction
PARAMETER MENU Menu LED is flashing quickly
Status-LED:
A
Swashplate -
cyclic center adjustment
B Control behavior
C Swashplate - pitching up behavior User
D Tail - HeadingLock gain
E Stick deadband
F Tail - torque precompensation IX)
G Cyclic response
H Pitch boost
*The AR7200BX included with your Blade 500 X helicopter is pre-programmed with these default settings. If you perform a factory reset on the included
AR7200BX will default back to these default Blade 500 X helicopter settings.
To perform a Blade 500 X AR7200BX factory reset, enter any Setup menu and press the setup button for 10 seconds. After performing the factory reset, you will
need to re-center the swashplate servos by using setup menu G.
If you update the firmware on the AR7200BX to non-Blade 500 X firmware, all Blade 500 X helicopter default settings will be deleted. You will need to
complete the entire AR7200BX setup process before flying the helicopter again. Please refer to the Spektrum AR7200BX instruction manual.
EN
All manuals and user guides at all-guides.com
OFF Purple
User 50 Hz
defined
User
960 μs
defined
User 50 Hz
defined
Tail stick - move to right endpoint and wait/left endpoint and wait
Reference ELE center
position pos.
User
mechanical
defined
nor|rev|rev nor|nor|rev*
Aileron stick – adjust 6° cyclic pitch on the roll axis (blades aligned with fuselage)
Collective stick on max and min position and use tail stick to adjust desired pitch.
Stock settings provide +/- 14 degrees of collective pitch.
Move aileron, elevator and pitch sticks – adjust max limits with tail stick
rev | rev rev | nor
OFF Purple
Aileron and elevator stick – reset with tail stick
User
normal
defined
very low
defined
User
very low
defined
User
1
defined
User off*
defined
User
normal
defined
User off*
defined
12
Red
Red Solid
Flashing
upright
(vertical)
65 Hz 120 Hz
760 μs
165 Hz 270* Hz
normal
AIL center
pos.
90° 120°*
nor|rev|nor
nor | rev
normal
Red
Red Solid
Flashing
sport pro
low medium*
low medium*
2* 3
low - nor high - nor
slightly increased
increased*
low medium
Firmware version 5003.0.0
Blue
Blue Solid
Flashing
flat
(horizontal)*
165 Hz 200 Hz*
1520 μs*
333 Hz 560 Hz
reversed*
PIT center
pos.
140° 140° (1=1)
nor|nor|nor
nor | nor*
reversed*
Blue
Blue Solid
Flashing
extreme transmitter*
high very high
high very high
4 5
low - rev high - rev
high very high
high very high