Flying Tips Continued; Post Flight Checklist - Horizon Hobby E-flite Bind-N-Fly UMX FPV RADIAN Mode D'emploi

EN
Flying Tips
Continued
Low Voltage Cutoff (LVC)
Low Voltage Cutoff (LVC) pulses the power to the
motor when the voltage gets low. When the motor
power pulses, land the aircraft immediately and
recharge the fl ight battery.
Disconnect and remove the Li-Po battery from the
aircraft after use to prevent trickle discharge. Fully
charge your Li-Po battery before storing it. During
storage, make sure the battery charge does not fall
below 3V per cell.
LVC does not prevent the battery from
overdischarge during storage.
IMPORTANT: The connected camera is always
drawing power from a connected battery.
NOTICE: Repeated fl ying to LVC will damage the
battery.

Post Flight Checklist

1. Disconnect the fl ight battery from the
ESC (Required for safety and battery
life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the
aircraft.
14
Repairs
Repair the aircraft using foam-compatible CA
(cyanoacrylate adhesive) or clear tape. Only use
foam-compatible CA, as other types of glue can
damage the foam. When parts are not repairable,
see the Replacement Parts List for ordering by
item number.
For a listing of all replacement and optional parts,
refer to the list at the end of this manual.
NOTICE: Use of foam-compatible CA accelerant on
your aircraft can damage paint. DO NOT handle the
aircraft until the accelerant fully dries.
NOTICE: When you are fi nished fl ying, never leave
the aircraft in direct sunlight or in a hot, enclosed
area such as a car. Doing so can damage the foam.
4. Recharge the fl ight battery.
5. Store the fl ight battery apart from the
aircraft and monitor the battery charge.
6. Make note of the fl ight conditions and
fl ight plan results, planning for future
fl ights.