Table des Matières
Publicité
eleVator serVo and stab installation •
16
Using a sanding drum with outside diameter of 5/16-inch enlarge the hole.
With this measurement, only male connector of extension fits through the hole
and female end won't fall inside the fuselage. This helps if stabilizers need to
be removed for transportation..
44
All manuals and user guides at all-guides.com
17
Pass the extension into the fuselage and leave the female lead outside. If
stabilizers will have to be removed for transportation, use a commercially
available safety clip to secure the servo lead to extension otherwise use a
heat shrink to secure the connector.
18
The stabilizer tube has R and L designation, for right side and left side respec-
tively. Plug the right stabilizer first into the stab tube and fuselage. Using blue
thread lock install the stab screw through the bottom of the stab into the tube.
Publicité
Table des Matières
