Table des Matières
Publicité
throttle serVo installation • • •
19
Temporarily power up the servo to the receiver, adjust the throttle travel. Make
all necessary changes for linkage length and servo arm. Make sure it is bind
free. If needed enlarge the hole for throttle rod in the dome.
All manuals and user guides at all-guides.com
20
Once satisfied, remove the tray and apply thread lock to servo arm center
screw and mount the arm. Apply servo tape to the back of the throttle servo
tray as shown in the picture above.
21
Mount the throttle servo tray using M3x16mm screws. Finalize the installation
by moving the piece of fuel tubing over the clevis
55
Publicité
Table des Matières
