Table des Matières
Publicité
engine dome preparation For da-120 • • •
4
Using a drill and 1/16-inch drill bit, make a pilot hole. Then use 1/8-inch,
¼-inch and 5/16-inch drill bits respectively and enlarge the hole.
46
All manuals and user guides at all-guides.com
5
Insert blind nuts and using a 4.5mm ball driver along with the 1-inch standoff
needed for the engine installation, pull the blind nuts in the engine dome.
6
Mark the top of the engine dome for ignition module and ignition battery
installation by tracing the outside of the ignition box and battery.
Publicité
Table des Matières
