Horizon Hobby HANGAR 9 Tiger 30cc Manuel D'utilisation page 9

35. Remove the screws, then apply a small amount of thin CA to
harden the threads made in the previous step.
36. After the CA has fully cured, secure the servo using the
screws provided with the servo.
37. Center the servo using the radio system. Place the control
horn on the servo so it is perpendicular to the servo.
38. Remove the unused arm from the servo. Use the diagram to
determine which arm to remove. When mounting the aileron
servos, the servo arms will face toward the wing tips on each
wing panel.
 Installing the aileron servos facing the opposite direction
allows their connection to the receiver using a Y-Harness.
39. When attaching the ball end to the servo arm, use the hole
that is 5/8 in (16mm) from the center of the servo horn.
Tiger 30cc ARF
40. Use a 1/8-inch (3mm) drill bit to enlarge the hole in the servo
arm.
41. Thread an M2 nut on one end of a 5
pushrod.
42. Slide a retainer over the barrel of the clevises.
43. Thread the clevis on the pushrod until the end of the pushrod
is visible between the forks of the clevis.
44. Thread a ball end 10-turns on the opposite end of the
pushrod.
5/8 inch
(16mm)
9
1 / -inch (140mm)
2
EN