Aileron Linkage Installation; Flap Linkage Installation - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

AILERON LINKAGE INSTALLATION

26. Remove the ball end from the aileron control horn. Assemble
the aileron link using two ball ends and a 116mm threaded
rod. Adjust the length of the rod to approximately 140mm.
27. Attach one ball end to the aileron control horn. Use two
washers, the M3 x 15 socket head cap screw and M3 locknut.
 Do not over-tighten the hardware and
damage the control horn or ball end.
28. Attach the opposite ball end to the servo arm using an M3 x
12 socket head cap screw, M3 washer and M3 lock nut. With
radio system on and the aileron servo centered, adjust the rod
to center the aileron servo
 Install the remaining aileron linkage.

FLAP LINKAGE INSTALLATION

29. Remove the ball end from the fl ap control horn. Assemble
the fl ap link using two ball ends and a 116mm threaded rod.
Adjust the length of the rod to approximately 150mm.
30. Attach one ball end to the aileron control horn. Use two
washers, the M3 x 15 socket head cap screw and M3 locknut.
Attach the opposite ball end to the servo arm using an M3 x
12 socket head cap screw, M3 washer and M3 lock nut.
 Do not over-tighten the hardware and
damage the control horn or ball end.
EN
31. With radio system on and the fl ap servo centered (in the mid-
fl ap position), adjust the rod to set the fl ap in the mid-fl ap
setting(1 9 / inches (40mm)).
16
32. Use the radio to set the fl ap servo to the full fl ap setting (3
inches (80mm)). Adjust the throw at the radio as necessary to
achieve the full fl ap position.
33. Use the radio to set the fl ap servo to the up fl ap setting.
Adjust the throw at the radio as necessary to achieve the up
fl ap position.
 Install the remaining flap linkage.
8
1 /
8