Hinging The Rudder - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

HINGING THE RUDDER

 Do not mix any epoxy until instructed to do so.
1. Apply a small amount of oil to the center of the hinge to prevent
epoxy from entering the hinge.
2. Insert the hinge so the center of the hinge pin aligns with the front
edge of the bevel on the control surface. Check that the hinge can
move freely.
3. Slide the hinge into position. Position the hinge so it is perpendicular
to the hinge line when fully defl ected.
4. Mix 1 ounce (30ml) of 30-minute epoxy. Remove the hinges, then
use a toothpick to apply epoxy inside each of the holes for the
rudder hinges.
5. Apply epoxy to the outside of the hinge using a toothpick
Timber 110 30–50cc ARF
6. Use a paper towel and isopropyl alcohol to remove any excess
epoxy. Check the alignment of the hinge.
7. Apply epoxy to the hinge and holes in the fi n.
8. Slide the rudder into position. Use a paper towel and isopropyl
alcohol to remove any excess epoxy. Allow the epoxy to fully cure for
all hinges before proceeding.
11 EN