Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation page 8

20. Remove the control horns. Place low-tack tape around the control
horn. The tape should be 1/32-inch (1mm) from the control horn as
shown.
21. Slide the control horn partially in the slot. Mix and apply 30-minute
epoxy to the control horn.
22. Slide the control horn slightly through the rudder so epoxy can be
applied on the opposite side.
23. Center the control horn and use a paper towel and isopropyl alcohol
to remove any excess epoxy.
24. Repeat the process for the remaining rudder control horn. Fit two
ball ends between the horns, then use M3 x 15 socket head cap
screws to keep the control horns aligned while the epoxy cures.
EN
25. Use a paper towel and isopropyl alcohol to remove excess epoxy
from between the control horns.
26. Before the epoxy fully cures, remove the tape from around the
control horn. Allow the epoxy to fully cure before proceeding.
27. Use a small amount of 5-minute epoxy the control horn plates
in position. Remove any excess epoxy using a paper towel and
isopropyl alcohol.
8