Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation page 10

11. Secure the servo ball link to the servo arm using an M3 x 15 socket
head cap screw, M3 washer and M3 lock nut. Use a 2.5mm hex
wrench and 5.5mm nut driver to tighten the hardware.
 The servo arm may not be threaded for metric hardware. It may
be necessary to drill and tap the hole for the M3 hardware, or drill
the hole over-size to pass the M3 screw through the servo arm.
12. Center the servo using the radio system. Attach the servo arm
parallel to the hinge line.
 The servo may require the use of sub-trim to properly
align the servo arm parallel to the hinge line. Try to
get the servo arm as close to center as possible, using
the radio system only for minor adjustments.
13. Attach the servo linkage to the control horn using an M3 x 15 socket
head cap screw, M3 washer and M3 lock nut. Use a 2.5mm hex
wrench and 5.5mm nut driver to tighten the hardware.
14. Use the wrench included with the airplane to adjust the linkage.
15. Continue to adjust until the aileron is aligned with the wing tip.
EN
16. Repeat the previous steps to install and adjust the fl ap linkage. This
installation will provide both up and down movement of the fl ap to
increase the aerobatic capabilities of this model.
 Repeat this section to install the remaining aileron and flap servos.
 Remember to turn the radio system off.
10