Configuring The Appliance In; Dbswin - Durr Dental VistaScan Mini Notice De Montage Et D'utilisation

Installation

8.4 Configuring the appliance in

DBSWIN

Configuration is carried out using VistaNetCon-
fig, which is automatically installed during instal-
lation of DBSWIN or VistaEasy�
Select Start > All Programs > Dürr Dental >
i
VistaConfig > VistaNetConfig�
EN
Click �
i
The list of connected units is updated�
Activate the connected unit in the Registered
i
column�
You can also register multiple units�
Configuring the device with a USB port
In the VistaNet device configuration window
you can change the device (Name) and check
the configuration�
Click on �
i
If necessary change the name�
i
Click Apply to save the configuration�
i
20
Configuring the device with a network con-
nection
The VistaNet unit configuration window allows
you to change the unit name (name), manually
enter an IP address or call up information�
Click �
i
If necessary change the name�
i
Click Apply to save the configuration�
i
Entering a fixed IP address (recommended)
To reset the network settings, keep the
unit reset key pressed for 15 - 20 sec-
onds while switching on�
Deactivate DHCP�
i
Enter the IP address, subnet mask and gate-
i
way�
Click on Apply�
i
The configuration is saved�
2141100009L30 1612V001