Driver Installation (Usb Port Only) - Durr Dental VistaScan Mini Notice De Montage Et D'utilisation

8.2 Driver installation (USB port
only)
Only connect the USB cable to the com-
puter when the installation wizard asks
you to do so�
Close all programs�
i
Insert the supplied DBSWIN DVD (version
i
5�3�1 or higher) into the DVD drive�
The start window opens�
If the DVD does not start to play automatical-
i
ly, double-click the file CD_Start.exe�
Select the required language�
i
Open the Drivers tab�
i
Click Duerr Dental Driver Installation�
i
Click OK to confirm� The Dürr Dental Driver
i
Setup installation wizard opens�
Follow the instructions of the installation wiz-
i
ard�
8.3 Configuring the unit in VistaSoft
Configuration is performed directly in VistaSoft�
> Select the unit�
i
2141100009L30 1612V001
Mark the connected unit in the list�
i
Click on Edit connection settings�
i
The unit name (designation) can be changed
i
and information queried working under Gen-
eral�
An IP address can be entered manually and
i
DHCP can be activated / deactivated working
under Connection�
Extended functions e� g� IP address 2 can be
i
set working under Extended�
Entering a fixed IP address (recommended)
To reset the network settings, keep the
unit reset key pressed for 15 - 20 sec-
onds while switching on�
Working under Connection, deactivate DHCP�
i
Enter the IP address, subnet mask and gate-
i
way�
Navigate back to Units via the navigation bar
i
or close Flyout using
The configuration is saved�
Testing the device
You can scan in an X-ray image to check that
the unit is properly connected�
Open VistaSoft�
i
Create an X-ray station for the connected unit�
i
Log-in the demo patient (patient ID:
i
DEMO0001)�
Select the image type (e� g� Intraoral)�
i
Scan an image plate, see "10�2 Scanning the
i
image data"�
Installation
�
19
EN