Commissioning And First Start-Up; Set Up The Network; Network Connection) - Durr Dental VistaScan Mini Notice De Montage Et D'utilisation

Installation
Connect the unit via the USB port (only
DBSWIN)
Only connect the USB cable to the com-
puter when the installation wizard asks
you to do so�
Remove the cover from the rear of the unit�
i
Connect the USB cable to the unit�
i
EN
The cover on the rear must be correctly
fitted when the unit is operated within the
vicinity of the patients�
Refit the cover�
i
18
8 Commissioning and first
start-up
NOTICE
Short circuit due to the build up of
condensation
Do not switch on the unit until it has
i
warmed up to room temperature and
it is dry�
The unit supports the following imaging pro-
grams:
– VistaSoft of Dürr Dental
– VistaConnect of Dürr Dental
– DBSWIN of Dürr Dental
– VistaEasy of Dürr Dental
– Third-party software on request
8.1 Set up the network (only for

network connection)

Network configuration
Various options are available for network config-
uration:
– Automatic configuration via DHCP�
– Automatic configuration via Auto-IP for direct
connection of unit and computer�
– Manual configuration�
Configure the network settings of the unit us-
i
ing the software or, if applicable, the touch
screen�
Check the firewall and release the ports, if ap-
i
plicable�
Network protocols and ports
Port Purpose
45123 UDP, Unit recognition and
45124 UDP configuration
2006 TCP Unit data
514 UDP Event protocol data
1)
2005 TCP, Diagnosis
23 TCP
The port can vary depending on the config-
1)
uration�
When the unit is first connected to a
computer, it applies the language and
time settings of the computer�
Ser-
vice
Syslog
Telnet,
SSH
2141100009L30 1612V001