Publicité
ULTRAFLEX
NOTICE
-
The installation must be carried out according to the prescriptions of the system manufacturer. The
hydraulic lines must be fixed by means of clips, belts or any other system preventing damage due to
friction or vibrations. The clips, the belts or the other devices must be corrosion resistant and must be
conceived to avoid cuts, abrasions or damage to the hydraulic lines. They must also be compatible with
the materials making up the hydraulic line.
-
The hydraulic lines must not go below the waterline.
-
During the first installation, in case of changes to the system components and when maintenance re-
quires disconnecting/connecting mechanical or hydraulic interfaces, some tests must be carried out to
check the integrity and the good operation of each steering system installed on the boat. In particular,
these tests must ensure the absence of any type of interference (see par. 4.1.1 and 4.1.2) and of leaks
from the hydraulic and mechanical components by submitting the system to a precise test pressure for
about 60 seconds.
HYDRAULIC CYLINDER FOR OUTBOARD ENGINE
Installation and Maintenance Manual
page 15
-
of 103
Publicité
