Dental Direkt DD Ti-Base 2CUT Notice D'utilisation page 10

US UNITED STATES (FDA)
The implant screw should be tightened with the system-specific torque.
The screw channel must always be sealed after the abutment is attached to the
implant.
Caution: The lab screw must not be used for inserting the implant components in
the patient.
Note: Restricted indications apply for the restoration of DD Solid Connect® CAD/
CAM Abutments on reduced-diameter implants, which can be found in the corres-
ponding instructions for use of the implant manufacturer.
Note: DD Solid Connect® CAD/CAM Abutments of the respective series can only
be combined with the corresponding compatible implant system. This also applies
to the corresponding platform diameters.
Disposal:
Dispose of waste according to applicable legislation.
Warranty:
Our products are subject to strict quality control and correspond to current
technical standards. Please refer to our current warranty terms and conditions for
further details.
Note: Any serious incident that has occurred in relation to the device should be
reported to the manufacturer and the competent authority to the Member State in
which the user and/or patient is established.
Our products are subject to continual development, so we reserve the right to
make changes. You will find the latest version of the instructions for use on our
homepage at: www.dentaldirekt.de/en
This version replaces the previous.
*Dental Direkt validated milling centers can be found at:
www.dentaldirekt.de/en/validated-milling-centers
Explanation of symbols:
Manufacturer
Date of manufacture
Batch code
LOT
Catalog number
REF
Keep dry
Non-sterile
Do not use if package is damaged
Torque
Consult electronic instructions for use
www.dentaldirekt.de/IFU
Caution: U.S. Federal law restricts this device to sale
by or on the order of a dentist
Do not re-use
Medical Device
UDI
Unique Device Identification
MR Conditional
Dental Direkt GmbH · Industriezentrum 106 – 108 · 32139 Spenge · Germany · Tel.: +49 5225 863190
eIFU_DD Ti-Base 2CUT_Rev.08_20240219
Instructions for use
DD Ti-Base 2CUT
10