AT&T TL96271 Guide D'utilisation page 87

Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. You have two ways to begin a PTT call:
• If you have one handset, press and hold PTT when the telephone base
is not in use.
-OR-
• If you have more than one handset, press PTT when the telephone
base is not in use. Then use the dialing keys to enter a handset
number (1-9 for handsets 1-9, TONE
TONE and 1 for handset 11 or TONE
or press CID or DIR
SELECT or PTT to create the push-to-talk session.
2. Your handset displays Connecting to HANDSET X... for a few seconds.
When the connection is made, both screens display Press and hold [PTT]
to talk and beep once.
3. Press and hold PTT on the telephone base. A chirp indicates your
microphone is on. Speak towards the MIC. Your voice is broadcast to the
destination handset. While you are speaking, the telephone base displays
PTT To HANDSET X (X represents the destination handset number).
4. Release PUSH TO TALK after speaking. Both handsets beep once again.
After the handsets beep, you can press and hold PUSH TO TALK to continue
speaking or the destination handsets can respond (see Answer a PTT call
on page 84).
5. To end the PTT call, press CANCEL or END. The handset displays Push to
talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one
presses PTT within 10 seconds, the PTT call ends automatically.
and 0 for handset 10,
and 2 for handset 12),
to scroll to the desired handset then press
81