Expand Your Telephone System; Adding And Registering Handsets (Optional) - AT&T TL96271 Guide D'utilisation

Appendix

Expand your telephone system

The cordless handset provided with your telephone system is already
registered. Additional handsets registered to the telephone system are
assigned in sequential order. For instance, if you already have HANDSET,
the new registered handset is assigned HANDSET 2 and your first handset is
then renamed as HANDSET 1. This telephone system accommodates up to
12 handsets.

Adding and registering handsets (optional)

You can add new handsets (TL90071, purchased
separately) to your telephone system, but each handset
must be registered with the telephone base before use.
When first purchased, each expansion handset shows
Put handset on BASE to register after a battery is
installed. Each handset should be charged without
interruption for at least 25 minutes before registering to
the telephone base. For more details on battery charging,
see the table on page 14.
To register a handset:
1. Make sure the handset is out of the telephone base or
charger and shows Put handset on BASE to register
before you begin registration.
2. Put the handset you wish to register on the telephone
base cradle, not the charger.
3. The handset displays Registering handset..., and the
telephone base screen displays Registering... Please
wait. It takes about 90 seconds to complete the registration
process. The handset displays HANDSET X Registered (X
represents the registered handset number), and beeps when
registration completes.
If registration fails, the system will automatically try to
register again. If it fails after the third try, the handset
displays Registration failed, then Put handset on
BASE to register. The telephone base screen displays
Registration failed and then returns to the idle screen.
This may take up to five minutes to occur. When the
handset displays Put handset on BASE to register, please
start again from Step 1 above.
NOTES:
• You cannot register a handset if any other system handset is in
use.
• Registration slots are full shows on the base screen while you
are doing Step 3 above.
136
Put Handset
on BASE
to register
Registering...
Please wait
Registering
handset...
HANDSET X
registered
HANDSET X
registered