AT&T TL96271 Guide D'utilisation page 80

Multiple handset use
Intercom
To mute while on an intercom call:
• Press MUTE/
DELETE
Microphone off for a few seconds.
To end an intercom call at the destination handset:
• Press OFF/
CANCEL
base or charger. Both screens display Intercom ended.
To end an intercom call at the telephone base:
• Press END or CANCEL. Both screens display Intercom ended.
NOTES:
• You can cancel the intercom call before it is answered by pressing
END on your originating handset.
• If you are calling all handsets, only the first handset to pick up can answer the
intercom call.
• If the destination handset does not answer the intercom call within 100 seconds, is in
the directory or caller ID log, or is out of range, the originating handset displays No
answer. Try again. and returns to idle mode.
Using the telephone base:
1. Press MENU on the handset in idle mode.
2. Press CID or DIR to highlight Intercom, then
press SELECT.
• If you have one handset, the telephone base displays
Calling HANDSET. The handset rings and displays
Base is calling.
• If you have more than one
displays INTERCOM and a list of registered handsets.
– Press CID or DIR to select a destination
handset and then press SELECT. Your handset
displays Calling HANDSET X, Calling BASE 0 or
Calling all devices when you choose Group.
-OR-
– Press 0 for BASE 0, 1-9 for HANDSET 1-9,
HANDSET 10,
HANDSET 12. Your handset displays Calling HANDSET X or Calling
BASE 0. The other handset rings and displays HANDSET X is calling.
-OR-
– Press TONE
The telephone base displays Calling HANDSET X. The destination
handset rings and displays BASE 0 is calling.
on the handset or telephone base. Its screen displays
, END or place either handset back in the telephone
handset, your handset
TONE and 1 for HANDSET 11 or
and then # (pound key) to call all handsets.
74
OFF/
CANCEL
Answering sys
Directory
Cal ler ID log
Intercom
BACK SELECT
INTERCOM
Handset
Handset
Group
BACK SELECT
TONE and 0 for
TONE and 2 for
or
2
3