Message Alert Tone - AT&T TL96271 Guide D'utilisation

Answering system
Answering system settings

Message alert tone

When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you to new messages. The tone stops when all new
messages have been reviewed. The default message alert tone setting is Off.
To change the setting:
Using a cordless handset:
1. Press MENU on the handset in idle mode to enter the
main menu.
2. Use CID or DIR to scroll to Answering sys, then
press SELECT.
3. Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
4. Press CID or DIR to scroll to Msg alert tone, then
press SELECT.
5. Press CID or DIR to choose between On and Off,
then press SET to save your setting. You hear a confirmation tone.
Using the telephone base:
1. Press MENU on the handset in idle mode to enter the
main menu.
2. Use CID or DIR to scroll to Answering sys, then
press SELECT.
3. Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
4. Press CID or DIR to scroll to Msg alert tone, then
press SELECT.
5. Press CID or DIR to choose between On and Off, then press
save your setting. You hear a confirmation tone.
NOTE: You cannot set the message alert tone when another handset or the telephone
base is accessing the answering system.
120
ANS SYS SETUP
# of rings
Remote code
Msg alret tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SET
ANS SYS SETUP
# of rings
Remote code
Msg alret tone
BACK SELECT
MSG ALERT TONE
OnHandset
Off
BACK SET
SET to