Ptt To A Group Of Handsets - AT&T TL96271 Guide D'utilisation

Multiple handset use
Push-to-talk (PTT)

PTT to a group of handsets

When there are multiple handsets registered to the phone system, PTT
supports one-to-group calls. PTT supports a maximum of one-to-four calls
when two to five handsets are registered, and a maximum of one-to-three
calls when six or more handsets are registered. The first four registered
handsets will be able to use this feature. Other handsets can only use PTT for
one-to-one calls.
Using a cordless handset:
1. To begin a PTT call to a group of handsets:
• Press and hold PUSH TO TALK when the handset is not in use.
-OR-
• Press PUSH TO TALK when the handset is not in use. Press TONE
and #, or press
PUSH TO TALK.
Your handset displays Connecting to group... for a few seconds. When
the connection is made, both your and the destination handsets display
Press and hold [PTT] to talk and beep once.
2. Press and hold PUSH TO TALK on your handset. A chirp indicates your
microphone is on. Speak towards the handset. Your voice is broadcast to
the destination handset. While you are speaking, the handset displays
PTT To handset X (X represents the destination handset numbers).
3. Release PUSH TO TALK after speaking. All handsets beep once again.
After the handsets beep, you can press and hold PUSH TO TALK to
continue speaking or the destination handsets can respond (see
Answer a PTT call on page 84).
4. Press OFF/
CANCEL
Push to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
NOTE: After PUSH TO TALK is released, the PTT call remains open for a short time. If no
one presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
CID or DIR to highlight Group then press
or END to end the PTT call. The handset displays
82
SELECT or