AT&T TL96271 Guide D'utilisation page 26

Bluetooth
Bluetooth setup
7. Your cell phone may require a passcode. In this case
the handset screen displays Check cellular. ENTER
PASS CODE. Enter the cell phone passcode into the
handset and press
8. Enter the PIN of the telephone base (the default PIN
is 0000) into your cell phone to continue the pairing
process. The handset displays Adding Cell Phone A to
device list...
9. When a device is successfully connected, the handset
displays Cell Phone A is added and connected to base. You hear a
confirmation tone. The corresponding status icon (
corresponding device light on the telephone base (DEVICE 1 or DEVICE 2)
turns on.
If you have trouble pairing your cell phone, it may not be compatible
with your TL96271/TL96371/TL96471. Check the Bluetooth
compatibility list at
NOTES:
• The pairing process may take up to one minute. If the pairing process fails, try again.
• If you put the handset back in the telephone base or charger while pairing, the process
is cancelled and the handset returns to idle mode.
• The steps for the pairing process may vary for different cell phones. If this happens,
follow the prompts on your cell phone and your
complete the pairing process.
• Refer to the user's manual of your cell phone on how to search for or add a new
Bluetooth device.
SET to save.
www.telephones.att.com
20
Adding
Cel l Phone A
to device
list...
Cel l Phone A
is added
and connected
to base.
1 or 2) displays. The
.
TL96271/TL96371/TL96471 to