Table des Matières
Publicité
Bluetooth
Bluetooth setup
Device list and connection
Up to four devices can be paired to the telephone base. All paired devices
are shown on the device list. To use a paired device, it must be in an active
slot (DEVICE 1 or DEVICE 2) on the device list and connected. Only one
Bluetooth cell phone or a headset can be on a call at a time.
Once you have paired a device with the telephone base, you do not need
to repeat the pairing procedure again unless you delete the device from the
device list.
NOTE: When connecting a Bluetooth device to the device list, all connected devices
will be temporarily disconnected until the procedure is complete. It may take up to two
minutes to reconnect.
Review the active device list
You can change the name of a paired device on the paired devices list.
1.
Press
MENU
on the telephone base in idle mode.
2.
Press
CID
or
DIR to highlight Bluetooth, then press SELECT.
3.
Press
CID
or
DIR to highlight Device list, then press SELECT.
Connect/disconnect an active device
While in the active devices menu, you may connect or disconnect your active
device.
1.
Press
MENU
on the telephone base in idle mode.
2.
Press
CID
or
DIR to highlight Bluetooth, then press
SELECT.
3.
Press
CID
or
DIR to highlight Device list, then
press SELECT.
4.
Press
CID
or
DIR to highlight a device when
necessary, then press OPTION.
5.
Press
CID
or
DIR to highlight Connect/Disconnect
(whichever is applicable), then press SELECT.
The handset displays Device connected/Device
disconnected. You hear a confirmation tone.
NOTE: When your active device is connected, you are prompted to
select Disconnect. When your active device is disconnected, you are
prompted to select Connect.
23
Directory
Cal ler ID log
Intercom
Bluetooth
BACK
SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK
SELECT
DEVICE LIST
D1:Headset A
D2:Cel l Phone A
Cel l Phone B
BACK
SELECT
HEADSET A
Connect
Remove
Rename
BACK
SELECT
Publicité
Table des Matières
Dépannage
