Voice Announce Caller Id; Website - AT&T TL96271 Guide D'utilisation

Telephone settings
Handset settings

Voice announce caller ID

You can set your handset and/or telephone base to announce the caller
ID information for incoming calls. The voice announce caller ID setting is
independent for each handset and telephone base.
To change the setting:
1. Press MENU on the handset in idle mode to enter
the main menu.
2. Press CID or DIR to highlight Settings, then
press SELECT.
3. Press CID or DIR to highlight Caller ID Annc, then press SELECT.
4. Press CID or DIR to highlight Handset or Base, then press SELECT.
5. Press CID or DIR to choose
SET to save. You hear a confirmation tone.
NOTE:
• When there are up to five handsets registered, the telephone system supports caller ID
announce for the telephone base and all handsets. If six or more handsets are registered,
the system supports caller ID announce for the first four registered handsets only.
• If the phone number of the incoming call match the last 7 digits of a directory entry, the
name will be announced as it appears in the entry.
• The phone number will be announced when the name is unknown, private or not
provided. Only the last 11 numbers of a phone number is announced.
• No information will be announced if both the name and number are private, unknown or
not provided.
• This feature is not supported with headsets.
• This feature does not announce information for call waiting calls.
• If both home and cell lines are ringing, only the caller ID information of the first ringing
line will be announced.
• The voice announce caller ID feature is available in English only.
• If you set the number of rings as 3 rings (page 118), the answering system may not
have enough time to announce the caller's full information.

Website

You can use this feature to view the AT&T website address.
1. Press MENU on the handset in idle mode to enter the main menu.
2. Use CID or DIR to scroll to Website, then press SELECT. The handset
screen shows the AT&T
website address.
3. Press OK to exit.
On or Off, then press
40