Add A Headset - AT&T TL96271 Guide D'utilisation

Bluetooth
Bluetooth setup

Add a headset

Before you begin, make sure that your Bluetooth enabled headset is not
connected to any other Bluetooth device. Refer to your headset user's
manual to learn how to search for or add new Bluetooth devices.
To pair and connect a headset:
1. Press MENU on the telephone base in idle mode to
enter the main menu.
2. Press CID or DIR to highlight Bluetooth, then press
SELECT
.
3. Press SELECT to choose Add device.
4. Press CID or DIR to highlight Add headset, then
press SELECT. The screen displays
followed by If headset is connected to cell, please
disconnect it. Press NEXT.
• If there is another headset already active, the screen
will show Only 1 headset in device list can be
ready for connection and prompt you to replace an
existing paired device (page 27).
• When you already have two active devices, the
handset shows Only 2 devices can be ready for
connection. The telephone base will deactivate
another headset from active slot automatically.
5. Press NEXT. The screen displays Pls set headset to
discoverable mode, then press NEXT.
• All devices that are connected to the telephone base
are temporarily disconnected.
5. The screen displays Searching for Bluetooth
headsets... Set your headset to discoverable mode
(refer to the user's manual of your headset).
6. When the screen displays the found devices, press
CID or DIR to highlight your headset and then
press NEXT.
7. Enter the PIN of your headset. The PIN for most
Bluetooth devices is 0000 (refer to the user's manual
of your headset). Then press NEXT.
Please wait...
21
Directory
Cal ler ID log
Intercom
Bluetooth
BACK SELECT
BLUETOOTH
Add device
Device list
Download dir
BACK SELECT
DEVICE LIST
Add cel lular
Add headset
BACK SELECT
Pls set headset
to discoverable
mode
BACK NEXT
Searching for
Bluetooth
headsets...
FOUND DEVICES
Headset A
Headset B
BACK SELECT
ADD HEADSET
ENTER PIN
Active devices
_ _ _ _
BACK NEXT