Set Date And Time - AT&T TL96271 Guide D'utilisation

Telephone settings
Telephone base settings

Set date and time

The answering system announces the day and time of each message prior to
playing it. If you subscribe to caller ID service, the day, month and time are
set automatically with each incoming call. If you do not want to set the date
and time automatically with caller ID information, turn this feature off (see
Use caller ID to automatically set date and time on page 38). However, the
year must be correct so that the day of the week can be calculated from the
caller ID information. Before using the answering system,
set the date and time as follows.
After registration or a power failure,
will prompt you to set the date and time
To set the date and time:
1. Press MENU on the telephone base in idle mode to
enter the main menu.
2. Press CID or DIR to highlight Set date/time, then
press SELECT.
3. Press CID or DIR to select the month, then press
SET, or enter the two-digit number (01-12) using the
dialing keys (0-9).
4. Press CID or DIR to select the day, then press SET, or enter the two-
digit number (01-31) using the dialing keys (0-9).
5. Press CID or DIR to select the year, then press SET, or enter the two-
digit number (00-99) using the dialing keys (0-9),
then press SET.
6. Press CID or DIR to select the hour, then press SET, or enter the
two-digit number (01-12) using the dialing keys (0-9).
7. Press CID or DIR to select the minute, then press SET, or enter the
two-digit number (00-59) using the dialing keys (0-9).
8. Press CID or DIR to highlight AM or PM, or press 2 for AM or 7 for PM.
Press SET to save. You hear a confirmation tone.
NOTE: If the date and time are not set when a message is recorded, the system announces,
"Time and day not set," before each message plays.
the telephone base
(see page 13).
50
Intercom
Bluetooth
Ringers
Set date/time
BACK SELECT
SET DATE
Active devices
01/01/11
MM/DD/YY
BACK SET
SET TIME
Active devices
06:08 PM
BACK SET