Remote Access Code - AT&T TL96271 Guide D'utilisation

Answering system
Answering system settings

Remote access code

A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can
change the code to any number from 00 to 99.
To change the remote code:
Using a cordless handset:
1. Press MENU on the handset in idle mode to enter the
main menu.
2. Use CID or DIR to scroll to Answering sys, then
press SELECT.
3. Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
4. Press CID or DIR to scroll to Remote code, then
press SELECT.
5. Use the dialing keys (0-9) to enter a two-digit number from 00-99.
• Press /DELETE to erase a digit.
MUTE
• Press and hold
MUTE
• Press CID or DIR to move the cursor to the right or left.
Press SET to save. You hear a confirmation tone.
Using the telephone base:
1. Press MENU on the telephone base in idle mode to
enter the main menu.
2. Use CID or DIR to scroll to Answering sys, then
press SELECT.
3. Use CID or DIR to scroll to Ans sys setup, then
press SELECT.
4. Press CID or DIR to scroll to Remote code, then
press SELECT.
5. Use the dialing keys (0-9) to enter a two-digit number from 00-99.
• Press DELETE/X to erase a digit.
• Press and hold DELETE/X to erase all digits.
• Press CID or DIR to move the cursor to the left or right.
Press SET to save. You hear a confirmation tone.
/DELETE to erase all digits.
119
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SET
ANS SYS SETUP
Cal l screening
# of rings
Remote code
BACK SELECT
REMOTE CODE
19
BACK SET