Configuring The Network - Aventics PROFINET-IO Mode D'emploi

94 AVENTICS | PROFINET-IO | R412015162–BDL–001–AE
Commissioning and Operation
Table 20: Coding of the single-bit diagnosis of the valve driver
Byte Valve slot
2
3
Diagnostic bit
9
10
11
12
13
14
15
16
The diagnostic messages can be activated with a DIP switch.
6.2
A device name must be assigned for a bus coupler slave to
function in the network. IP addresses and subnet masks can be
assigned. Otherwise the configuration software will create
automatic assignments. The following example is based on the
SIMATIC software from Siemens.
The work described here may only be carried out by
qualified electronics personnel and in compliance with the
operator's documentation on configuring the PROFINET-IO
controller, as well as applicable technical standards,
directives, and safety regulations.
Short circuit or open load in valve solenoid
D2.0
D2.1
D2.2
D2.3
D2.4
D2.5
D2.6
D2.7
D3.0
D3.1
D3.2
D3.3
D3.4
D3.5
D3.6
D3.7

Configuring the network

A (14)
B (12)
A (14)
B (12)
A (14)
B (12)
A (14)
B (12)
A (14)
B (12)
A (14)
B (12)
A (14)
B (12)
A (14)
B (12)